These ubolts have been developed to enable pipes to be securely guided with a minimum of friction so safe-guarding the pipe from expansion & contraction wear due to temperature changes; whilst also reducing the noise & vibration of the pipe.
They are fitted with a gap between the ubolt and the pipe enabling the pipe to expand & contract yet keeping it fully guided in position.
The rubber base pad acts to reduce the noise & vibration of the pipes as they carry their fluid and it is fitted with a PTFE strip to reduce the friction and hence protects the pipe as it expands & contracts.
The patented-pending ubolt sleeve is a low friction silicone rubber which rotates around the ubolt to enable the pipe to move unrestricted but be fully guided in position on the supporting framework.
These are a much cheaper and more reliable solution to the conventional rubber lined ubolts which have PTFE bonded to the inside surface of the rubber coated ubolt.
Although Ubolts with the PTFE strip bonded to the rubber profile around the ubolts have been in common use for many years, they are prone to the PTFE separating from the rubber due to the difference in the expansion coefficient of the rubber and the PTFE. This problem is eliminated by Graphskill’s unique solution of a single medium with minimal friction.
Used to prevent galvanic corrosion due to the contact of dissimilar metals in the presence of an electrolyte. Also, for the prevention of wear and / or crushing of composite, thin wall or non ferrous pipework
U-Bolt is zinc plated mild steel
NB = 25 mm
Pipe O/D = 33.7 mm
A = 36 mm
B = 50 mm
C = 75 mm
D = 6 mm
E = 60 mm
F = 65 mm
G = 17 mm
H*T (backing pad) = 25*10 mm
Tolerance on dimensions +/- 1 mm. Please note that as we use roll threading, the bar diameter is slightly less than the thread diameter
Neoprene Rubber. A multi-purpose material suitable with weathering, sea water mineral oils and grease applications. Good flame retardant, excellent acid resistance, good ozone and oxidation resilience. Not suitable for resistance to aliphatic and aromatic hydrocarbons and ketones.
Hardness: 65 shore A +/-5
Tensile MPA: 5 MIN
Tear Strength: 20 Kg/CM
Compression Set: 35%
Operating Temperature: -20 / +110 C